Dell PowerEdge R340

By default UEFI boot mode is enabled in the lcfg/hw/dell_poweredge_r340.h hardware header. To match this it is necessary to switch from legacy to UEFI, this is done through the "System BIOS" -> "Boot Settings" section of the BIOS setup. Alternatively the legacy mode can be used by defining the USE_LEGACY_BOOT macro at the top of the LCFG profile.

-- squinney - 2019-04-05

This topic: LCFG > DocsForLCFGUsers > HardWare > HardWareDellPowerEdgeR340
Topic revision: r2 - 2019-04-05 - squinney
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2020 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback